Sail Panels

After some doing I finally found a guy who was selling these sail panels that I think will work perfect for my build since the hatchback will be on there I need to get air flow into the engine compartment and these are a great way to do it.

Below are the fiberglass parts I got.





As you can see these are going to take a lot of work to make them look as close to the stock ones as possible since I am painting them black.

Comments

Post a Comment

Popular posts from this blog

Coil pack mounting.

Image
Got my Coil packs today. I used a coil mount from a non Supercharged 2000 Pontiac Grand Prix GT 3800 this works perfectly to mount the coils close to the left trunk side of the Fiero and will allow me to use stock 3800 length spark plug wires which I have chosen to use the zzp 10.5 wires. I did have to buy some longer 10/32 x 1 1/2 mounting screws to attach the coils to the brackets as my stock Ines were not long enough.
Read more

Found my Donor engine and transmission

Image
I searched high and low to find a low Mile 3800 Supercharged engine and transmission for my swap. I finally found one in Houston Texas. Cost me a bit more than I would have liked but it was one of the only ones I could find with low miles at just over 50k miles. It was in a 2004 Pontiac Grand Prix GTP.  At the time I did not get very good information as to what all was needed for the swap other than engine trans wiring harness computer and axles. Now I know better that I didn't need the wiring and computer from that car since it is a drive by wire in 04 and my Fiero is drive by cable so in order to make it work in my Fiero I need a 1997-2003 wiring harness and pcm. Would have been nice to know this before I bought the wrong stuff. Hopefully I can sell the 04 wiring harness and pcm and get some of my money back.
Read more