Black 88 Fiero Formula T Top car

Finally got it home and had a chance to hose it down and check it over and start taking it a part to make it my own.








































Comments

  1. SwanthogFebruary 12, 2021 at 2:43 PM

    Any chance you still have that Syclone tach and want to sell it to me?
    lawrence.falkenstein@outlook.com

    ReplyDelete
  2. Eren yeagerMarch 23, 2022 at 7:51 AM

    There must be a way to use curing to permanently adhere the coating to the surface since it can be pulled off so easily. Curing outdoor furniture, such as patio tables and chairs, is accomplished by carefully placing the powder in an industrial powder coating oven and allowing it to acquire adhesive characteristics. It's important that the temperature of the oven be set such that the powder may be dissolved into the liquid. In a liquid state, materials stick to a surface far more easily than in a solid-state. To do this, the powder must be cured in order to dissolve and become more adherent to your patio furniture.

    ReplyDelete

Post a Comment

Popular posts from this blog

Coil pack mounting.

Image
Got my Coil packs today. I used a coil mount from a non Supercharged 2000 Pontiac Grand Prix GT 3800 this works perfectly to mount the coils close to the left trunk side of the Fiero and will allow me to use stock 3800 length spark plug wires which I have chosen to use the zzp 10.5 wires. I did have to buy some longer 10/32 x 1 1/2 mounting screws to attach the coils to the brackets as my stock Ines were not long enough.
Read more

Found my Donor engine and transmission

Image
I searched high and low to find a low Mile 3800 Supercharged engine and transmission for my swap. I finally found one in Houston Texas. Cost me a bit more than I would have liked but it was one of the only ones I could find with low miles at just over 50k miles. It was in a 2004 Pontiac Grand Prix GTP.  At the time I did not get very good information as to what all was needed for the swap other than engine trans wiring harness computer and axles. Now I know better that I didn't need the wiring and computer from that car since it is a drive by wire in 04 and my Fiero is drive by cable so in order to make it work in my Fiero I need a 1997-2003 wiring harness and pcm. Would have been nice to know this before I bought the wrong stuff. Hopefully I can sell the 04 wiring harness and pcm and get some of my money back.
Read more