Ceramic coating done to power logs and crossover pipe

Before and after photos of my power Logs that have been Ceramic coated inside and out. Like many things this was a bit pricey but I am hoping it will help with engine bay temps. The cost just for these to be coated was $400.00 and after buying the power Logs for $350.00 ugh Yeah it's not a cheap build by any means.


Comments

  1. Rozer BaineMarch 2, 2021 at 11:02 PM

    I liked your work and the way in which you have shared this article here about Ceramic coating. It is a beneficial and helpful article for us. Thanks for sharing an article like this.Custom soft magnetics for sale online in USA

    ReplyDelete
  2. Olivia WilsonMarch 10, 2022 at 7:15 AM

    Eptex Coatings has electric powder coating ovens available right now via their website. To cure the powder, you'll still need a separate heat source. When it comes to optimizing your garage's available space, consider using soft lighting and modest burners.

    ReplyDelete
  3. Quality Auto Glass TintFebruary 25, 2024 at 6:35 PM

    The Armor All Wheel and Tire Cleaner combo pack is a car care dream! The Extreme Shield + Ceramic Wheel Cleaner and Tire Shine Spray deliver an impressive, long-lasting shine, making my wheels and tires look brand new with minimal effort. Quality Auto Glass Tint Inc. Salida

    ReplyDelete
  4. Quality Auto Glass Tint Inc. SalidaApril 14, 2024 at 6:48 PM

    Ceramic coating on power logs and crossover pipe not only enhances performance but also adds durability and a sleek look. A wise investment indeed.Quality Auto Glass Tint Inc. Salida

    ReplyDelete
  5. Quality Auto Glass Tint Inc. SalidaApril 24, 2024 at 8:18 PM


    Ceramic coating on power logs and crossover pipe enhances durability and heat resistance, ensuring optimal performance and longevity. A smart investment for engine protection.Quality Auto Glass Tint Inc. Salida.

    ReplyDelete

Post a Comment

Popular posts from this blog

Coil pack mounting.

Image
Got my Coil packs today. I used a coil mount from a non Supercharged 2000 Pontiac Grand Prix GT 3800 this works perfectly to mount the coils close to the left trunk side of the Fiero and will allow me to use stock 3800 length spark plug wires which I have chosen to use the zzp 10.5 wires. I did have to buy some longer 10/32 x 1 1/2 mounting screws to attach the coils to the brackets as my stock Ines were not long enough.
Read more

Found my Donor engine and transmission

Image
I searched high and low to find a low Mile 3800 Supercharged engine and transmission for my swap. I finally found one in Houston Texas. Cost me a bit more than I would have liked but it was one of the only ones I could find with low miles at just over 50k miles. It was in a 2004 Pontiac Grand Prix GTP.  At the time I did not get very good information as to what all was needed for the swap other than engine trans wiring harness computer and axles. Now I know better that I didn't need the wiring and computer from that car since it is a drive by wire in 04 and my Fiero is drive by cable so in order to make it work in my Fiero I need a 1997-2003 wiring harness and pcm. Would have been nice to know this before I bought the wrong stuff. Hopefully I can sell the 04 wiring harness and pcm and get some of my money back.
Read more